Mercury 90-863160

BRAVO THREE GEAR HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3D-23
Outer Propeller Shaft Servicing
1. To remove roller bearing and oil seal from outer propeller shaft using slide hammer puller
with three-jaw puller.
72216
a
b
a-Slide Hammer Puller (P/N 91-34569A1)
b-Outer Propeller Shaft
2. Install roller bearing using bearing installation tool.
72217
a
b
a-Bearing Installation Tool (P/N 91-805352T)
b-Outer Propeller Shaft
3. Coat outer diameter of oil seal with Loctite 271. Press oil seal into outer propeller shaft
using seal installation tool until tool bottoms out against shaft. Lubricate lips of oil seal
and fill area between lips of seal with Quicksilver Special Lubricant 101.
72235
a
b
a-Seal Installation Tool (P/N 91-805358T)
b-Outer Propeller Shaft