Mercury 90-863160

DRIVE SHAFT HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3A-53
Bearing Sleeve Installation
1. Install driver head onto puller guide. Secure driver head to puller guide with screw. Place
bearing sleeve against edge of driver head as shown.
22084
a
b
c
d
a-Driver Head (91-862530)
b-Puller Guide (91-90774)
c-Screw (91-90775)
d-Bearing Sleeve
2. Place driver guide onto top cover as shown. Install puller guide assembly through driver
guide assembly and install bearing sleeve by tapping into place until tool bottoms out.
22082
a
a-Driver Guide (91-90244A1)
3. Place driver guide into top of drive shaft housing, as shown. Install puller guide assembly
through driver guide and install bearing sleeve by tapping into place until tool bottoms out.
22263
a
a-Driver Guide (91-90244)