SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY SERVICE MANUAL NUMBER 28
Page 4A-30 90-863160 MAY 2000
Exhaust Tube (If Equipped)
Removal
NOTE: It is not necessary to remove drive unit when replacing exhaust tube.
CAUTION
Support aft end of drive unit when working between bell housing and gimbal hous-
ing.
1. Raise drive unit to the full UP position.
2. Loosen clamp and remove exhaust tube.
22184
a
b
a-Clamp
b-Exhaust Tube
Cleaning and Inspection
1. Inspect exhaust tube for charring, cracks, cuts and hardening.
2. Roughen exhaust tube mating surfaces with sandpaper and wipe clean with lacquer
thinner.
To Next Page
Loading...
