Mercury 90-863160

DRIVE SHAFT HOUSING SERVICE MANUAL NUMBER 28
Page 3A-26 90-863160 MAY 2000
Shifter Reassembly
1. Install shifter shaft lower bushing and oil seal as follows:
a. Install lower bushing part way into bore as shown.
22223
22459
a
a
a-Lower Bushing
b. Place oil seal onto bearing and seal driver with lip of seal facing upward. Apply Loc-
tite 271 to outside diameter of seal before installation.
22263
22459
b
a
a-Oil Seal
b-Seal Driver (91-17275A1)
c. Place bearing and seal driver with oil seal into bore from bottom. Place screw pilot
through bushing from top. Install screw through screw pilot and into bearing and seal
driver.
22459
22223b
c
a
a-Seal Driver
b-Screw Pilot
c-Screw