Mercury 90-863160

POWER STEERING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 6A-21
4. Install components shown. Torque fitting to 35 lb-ft (47 Nm).
a
b
cd d
76869
a-Fitting Assembly
b-Control Valve Assembly
c-Flow Control Spring
d-New O-rings
Pump Shaft Oil Seal Replacement
1. Remove pump pulley.
76895
a
a-Kent Moore Pulley Removal Tool (J-25034)
2. Push a .005 in. (0.13 mm) shim stock past oil seal until it bottoms in pump body (approxi-
mately 2-1/2 in. [64 mm] long).
76830
a
b
a-Oil Seal
b-Shim Stock