BRAVO THREE GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3D-38 90-863160 MAY 2000
5. Install outer propeller shaft bearing retainer nut, by turning counterclockwise, using out-
er propeller shaft bearing retainer installation tools. Torque to 200 lb-ft (271 Nm).
NOTE: To ensure proper thread engagement, start retainer nut by hand. Turn retainer nut
clockwise until thread engagement is felt then turn counterclockwise.
72274
c
b
a
a-Bearing Retainer Installation Tool (P/N 91-805382T)
b-Bearing Carrier Tool (P/N 91-805374)
c-Bearing Retainer
6. Apply Quicksilver Special Lubricant 101 to threads and O-ring surface area of bearing
carrier and install O-ring on bearing carrier. Fill area between seals with same lubricant.
Apply Quicksilver Perfect Seal to tapered surface of bearing carrier that comes in con-
tact with housing.
CAUTION
Bearing carrier has a LEFT-HAND THREAD. Install by turning COUNTERCLOCK-
WISE.
7. Install bearing carrier, by turning counterclockwise, using bearing carrier installation
tool. Torque to 150 lb-ft (203 Nm).
NOTE: To ensure proper thread engagement, start retainer nut by hand. Turn retainer nut
clockwise until thread engagement is felt then turn counterclockwise.
75895
b
a
a-Bearing Carrier Installation Tool (P/N 91-805374--1)
b-Bearing Carrier
To Next Page
Loading...
