REMOVAL, INSTALLATION AND ADJUSTMENTS
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 2A-27
13. Place a large I.D. flat washer and bushing on each end of the anchor pin. Be sure to
install the bushings with the small diameter end facing outward.
22029
a
c
c
b
a-Anchor Pin
b-Large I.D. Washers
c-Bushings
14. Loosen the nuts which secure the trim cylinders to the forward anchor pins. Move the
cylinder pivot ends outward and place them over the aft anchor pin.
15. Place the bushings (with the smaller diameter end facing inward) and the small I.D. flat
washers onto each end of the anchor pin. Install locknuts.
16. Tighten the forward and aft anchor pin locknuts until the locknuts and washers contact
against anchor pin shoulder.
17. Attach the trim cylinder caps hand tight. If the caps will not catch the threads, recheck
the tightness of the anchor pin nuts.
22029
a
b
c
d
e
a-Trim Cylinder Pivot Ends
b-Bushing
c-Small I.D. Flat Washer
d-Locknut
e-Trim Cylinder Cap
To Next Page
Loading...
