Chapter 1—Introduction
7
➀ Reference numbers listed are the original document numbers. If a document has been revised, the listed number will be followed by a
revision number, for example R10/97.
Topics Not Covered Here Some of the circuit monitor’s advanced features, such as on-board data log
and event log files, must be set up over the communications link using
POWERLOGIC application software. This circuit monitor instruction bulletin
describes these advanced features, but does not tell how to set them up. For
instructions on setting up these advanced features, refer to the appropriate
application software instruction bulletin.
RELATED DOCUMENTS Several optional add-on modules are available for use with the circuit
monitor. Each module is shipped with an instruction bulletin detailing
installation and use of the product. Available add-on modules for the
circuit monitor are listed below.
Instruction Bulletin Title Reference No.
➀
• POWERLOGIC Control Power Module (CPM-48) 3090IM9305
• POWERLOGIC Ride-Through Module 3090IM9701
• I/O Modules (IOM-11/44/18) 3020IM9304
• I/O Modules (IOM-4411/4444) 3020IM9401
• Voltage/Power Module 3090IM9302
• Optical Communications Interface (OCI-2000) 3090IM9303
• Ethernet Communications Module (ECM-2000/ECM-RM) 3020IB9818