Chapter 4—Front Panel Operation
39
CHAPTER 4—FRONT PANEL OPERATION
CHAPTER CONTENTS This chapter tells how to set up the circuit monitor from the front panel only.
Some advanced circuit monitor features, such as event log/data log
configuration, must be set up over the communications link. You can set up
these advanced features using POWERLOGIC software. Refer to the
software instruction bulletin for instructions on setting up advanced
features.
The Setup Mode ......................................................................................................40
The Configuration Option............................................................................. 40
The Resets Option........................................................................................... 40
The Alarm/Relay Option .............................................................................. 40
The Diagnostics Option ................................................................................. 40
Choosing a Setup Option ................................................................................41
How the Buttons Work ....................................................................................41
Configuring the Circuit Monitor .......................................................................... 42
Factory Defaults.............................................................................................. 42
General Configuration Procedure................................................................ 42
Viewing Configuration Data in Protected Mode ....................................... 45
Setting the Master Password ........................................................................ 46
Setting the CT Ratios ...................................................................................... 47
Setting the PT Ratio ........................................................................................ 48
Setting the System Type ................................................................................ 48
Setting the Demand Interval ......................................................................... 49
Setting the Watthour/Pulse Output ............................................................ 51
Setting the Device Address ........................................................................... 52
Setting the Baud Rate ..................................................................................... 53
Setting the Nominal Frequency .................................................................... 54
Resetting Demand, Energy, and Min./Max. Values ................................. 55
Performing Resets Using The Resets Option ......................................................56
Setting Up Alarm/Relay Functions ..................................................................58
General Setup Procedure...............................................................................59
Detailed Setup Procedure .............................................................................60
Viewing Active Alarms........................................................................................63
Viewing the Priority 1 Log..................................................................................64
Clearing the Priority 1 Log .................................................................................65
To Next Page
Loading...
Need help?
General