PAGE 14 Metor 6M
Installation and Operating Manual
5. INSTALLATION SITE 92102916 REV 5
Radiated electrical interferences
The distance between electrical
interference sources and the receiver coil
should be maximized. Recommended
minimum distance is from 0.5 m to 4 m
(20 in - 157 in). However, the exact
distance has to be determined for each
case separately, i.e. by moving the WTMD
and the interference source in respect to
each other until the optimal position is
found.
Interference may be generated by electrical
control panels, radio and computer
equipment, video monitors, powerful
electric motors and transformers, AC power
lines, thyristor control circuits, flickering
fluorescent lighting, and arc welding
equipment.
Conducted electrical interferences
Plug the power cord to a line not sharing
any heavy loads, like large electric motors.
They can cause major power or voltage
surges in the line.
NOTICE
When the equipment is in ready state, and no more than 2 - 4 boxes are
flashing on the display, the distance to sources of interference is sufficient.
> 0.5 (20 in)
To Next Page
Loading...