￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
855 Robotic Titrosampler
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 The 855 Robotic Titrosampler in the Titrando system ...... 1
1.2 Instrument description ......................................................... 2
1.2.1 Model versions ........................................................................ 3
1.2.2 Instrument components ........................................................... 4
1.2.3 Intended use ........................................................................... 4
1.3 About the documentation ................................................... 5
1.3.1 Symbols and conventions ........................................................ 5
1.4 Safety instructions ................................................................ 6
1.4.1 General notes on safety ........................................................... 6
1.4.2 Electrical safety ........................................................................ 6
1.4.3 Tubing and capillary connections ............................................. 7
1.4.4 Personnel safety ....................................................................... 7
1.4.5 Flammable solvents and chemicals ........................................... 9
1.4.6 Recycling and disposal ............................................................. 9
2 Overview of the instrument 10
2.1 Front and rear ..................................................................... 10
2.2 Back panel ........................................................................... 12
2.3 Sensor connectors .............................................................. 12
2.4 Sample racks ....................................................................... 13
3 Installation 15
3.1 Setting up the instrument .................................................. 15
3.1.1 Packaging .............................................................................. 15
3.1.2 Checks .................................................................................. 15
3.1.3 Location ................................................................................ 15
3.2 Preparing the Sample Processor ....................................... 15
3.2.1 Connecting the instrument to the power grid ........................ 15
3.3 Connecting a computer ...................................................... 16
3.4 Connecting the Swing Head .............................................. 18
3.5 Configuring the robotic arm .............................................. 19
3.6 Mounting the robotic arm ................................................. 21
3.7 Robotic arms with beaker sensor ..................................... 23
3.8 Installing the rinsing and aspiration equipment .............. 24
3.9 Placing tubing and cables in the guide chain .................. 27
3.10 Equipping the titration head ............................................. 28
To Next Page
Loading...
Need help?
General
