Metrohm 883 Basic IC plus - Default Chapter; Table of Contents

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
883 Basic IC plus
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 2
1.3 Safety instructions ................................................................ 3
1.3.1 General notes on safety ........................................................... 3
1.3.2 Electrical safety ........................................................................ 3
1.3.3 Tubing and capillary connections ............................................. 4
1.3.4 Flammable solvents and chemicals ........................................... 4
1.3.5 Recycling and disposal ............................................................. 4
1.4 Symbols and conventions .................................................... 5
2 Overview of the instrument 6
2.1 Front ...................................................................................... 6
2.2 Rear ........................................................................................ 7
3 Installation 8
3.1 About this chapter ................................................................ 8
3.2 Initial installation .................................................................. 8
3.3 Installation diagram ........................................................... 11
3.4 Setting up the instrument .................................................. 14
3.4.1 Packaging .............................................................................. 14
3.4.2 Checks .................................................................................. 14
3.4.3 Location ................................................................................ 14
3.5 Capillary connections in the IC system ............................. 14
3.6 Installations on the rear of the instrument ...................... 17
3.6.1 Positioning and connecting the detector ................................ 17
3.6.2 Transport locking screws ........................................................ 18
3.6.3 Installing the drainage tubing ................................................ 19
3.7 Capillary and cable feed-throughs .................................... 21
3.8 Connecting the eluent bottle ............................................. 23
3.9 Installing the high-pressure pump .................................... 27
3.10 Installing an inline filter ..................................................... 27
3.11 Installing the pulsation absorber ...................................... 28
3.12 Injection valve ..................................................................... 29
3.13 Suppressor ........................................................................... 31
3.13.1 General information on the suppressor .................................. 31
3.13.2 Installing the suppressor ........................................................ 31