Metronix ARS 2100 SE Series User Manual

Page 114
10 Initial operation
10.1 General notes on connection
Since the laying of the connection cables is very important in terms of EMC, make sure
to comply with chapter 8.14.4 EMC compliant cabling (page 111)!
DANGER!
Noncompliance with chapter 2 Safety notes for electrical drives and controllers (page
15) may result in property damage, person injury, electric shock or in extreme cases in
death.
10.2 Tools / material
 Screwdriver for slotted head screws size 1
 Rotary angle encoder cable
 Motor cable
 Power supply cable
 Operator panel ARS 2000 or control
 Possibly also Connector set: Power- and DSUB connector
10.3 Connecting the motor
 Plug the connector of the motor cable into the corresponding socket of the motor and screw tight
 Plug PHOENIX connector into socket [X6] of the servo drive
 Connect the PE line of the motor to the PE socket
 Plug the connector of the encoder cable into the encoder output socket of the motor and screw
tight
 Plug the D-Sub connector into the socket [X2A] Resolver or [X2B] Encoder of the servo drive
and fasten the bolting screws
 Apply the shield of the motor or angle encoder cable over a large contact area with the aid of the
shield connection clamp SK14
 Check all connections again
Product Manual „Servo drives ARS 2100 SE“ Version 5.0

Metronix ARS 2100 SE Series Specifications

General

Brand	Metronix
Model	ARS 2100 SE Series
Category	Servo Drives
Language	English