Metronix ARS 2100 SE Series User Manual

Page 115
10.4 Connecting the servo drive ARS 2100 SE to the
power supply
 Make sure that the power supply has been switched off
 Plug the PHOENIX connector into socket [X9] of the servo drive
 Connect the PE line of the mains to the PE socket
 Connect the 24 V connections to a suitable power supply unit
 Make mains supply connections
 Check all connections again
10.5 Connecting the PC (USB interface)
 Plug the plug A of the USB interface cable into the socket for the USB interface of the PC
 Plug the plug A of the USB interface cable into the socket [X19] USB of the ARS 2100 SE servo
drive
 Check all of the plug-and-socket connections once more
Now, you can communicate with the servo drive via the parameterisation program Metronix
ServoCommander
®
. For further information, please refer to the Software Manual “Servo drives
ARS 2000”.
10.6 Checking operability
1. Make sure the controller enabling switch is turned off
2. Switch on the power supply of all devices. The READY / ERROR LED on the front of the servo
drive should now be active green
If the READY LED does not light green but red, there is a malfunction. If the seven-segment display
indicates a number sequence, it is displaying an error message. You have to take care of the
corresponding problem. In this case please continue with chapter 11.2.2 Error messages (page 120). If
the device displays nothing, follow these steps:
1. Switch off the power supply
2. Wait 5 minutes, so the DC bus can discharge
3. Check all connection cables
4. Check the functionality of the 24 V power supply
5. Switch the power supply back on
Product Manual „Servo drives ARS 2100 SE“ Version 5.0

Metronix ARS 2100 SE Series Specifications

General

Brand	Metronix
Model	ARS 2100 SE Series
Category	Servo Drives
Language	English