Manual Corvus-eco
Starting up 27
Notices for the joystick mode
•
During power up the zero value of the joystick axes
are checked. Due this, the joystick axes may not be
deflected this time.
If the zero value of a joystick axis is out of a deter-
mined value, the manual mode for this axis is dis-
abled.
• If the joystick is disconnected during a manual posi-
tioning, the axes are stopped immediately.
The joystick mode remains active.
• For safety reasons the joystick will be switched off
automatically if a programmed move is performed.
Afterwards the joystick has to be switched on.
To Next Page
Loading...