Manual Corvus-eco
Functions 44
Programming mode
Corvus-eco is programmed via the RS-232 or USB interface.
The command language is Venus-1.
The principle of the host control
There are reading commands and writing commands.
Writing commands execute the activities. Reading com-
mands are u
sed to check the controller configuration resp. the
current state.
An automatic status reply message
can be generated by a
combination of commands, see example.
During a positioning task is executed, the status of the con-
troller and the current coordinates can be replied.
The Venus-1 command language is described in a second
part of the Corvus-eco documentation.
To Next Page
Loading...