97
Take out the rack
The fitting back is made at the reverse from the removal
operations
GAITER CHANGE
ON THE RACK
REPAIR RACK KIT
After having taken down the hubs.
Cut the fixing plastic collar gaiters and make the gaiters
slided to the exterior.
Fit back the new gaiters taking care to grease the rack
Use a standard grease.
Hardness regulating of the steering control. A regulating screw on
the rack allows the hardness of the steering to incresa or to
decrease.
For each regulating of the hardness of the rack
you must punch the nut to avoid it to
get out of control.
A repair steering rack kit which contains a bush + bearing +
joints is available under the reference :
1 002 788
Take out the waterproof bush.
Take out the inside circlip to take out the rack axle
Connecting rod
After having taken out the gaiter, with a screwdriver, take out the fins
of the brake washer of the notches of the ball joints.
With a vice pliers, untighten the connecting rod and take out
the connecting .
Crimp again the lock washer after the fitting of
the new connecting rod.
To Next Page
Loading...
