AccuPyc II 1340 Installing the Analyzer
June 2013 2-7
9. If connecting a printer:
a. Connect one end of the printer cable to a USB connector. Connect the other end to the
input connector on the printer.
b. Press
Alt + 2 to access the Set-up function
c. Press
CHOICE until Report Options displays on the fourth line of the display (refer
to Report Options, page 3-14), then press
ENTER.
d. Press
ENTER until the Print Report? prompt displays; press CHOICE to select Yes.
e. Press
ENTER until the Printer? prompt displays; choose the appropriate printer (refer
to SUPPORTED PRINTERS, page G-1 for information on supported printers.
f. Press
SAVE to save your selections and return to the Reload prompt.
10. If you have a temperature-controlled AccuPyc, attach the circulating bath (refer to
TEMPERATURE-CONTROLLED ACCUPYC, page F-1) before proceeding with the
next step.
11. Plug the printer power cord and the pycnometer power cord (which is plugged into the
AC/DC power supply) into an appropriate power source.
To Next Page
Loading...
