Micromeritics AccuPyc II 1340 - Page 53

AccuPyc II 1340 System Commands
Aug 2013 3-19
Does not display for Specify
Displays when you choose DHCP for the first time.
Press
ENTER; the system automatically tries to assign an IP
address. If the system is able to determine an address, the
following prompt containing the assigned address is
displayed.
If an address cannot be determined, this prompt is
displayed.
Press
Alt + CLEAR to cancel the operation and return to the
Reload prompt. Contact your IT Department, or choose the
Specify option and enter the appropriate information.
Does not display for DHCP
Displays when you choose Specify, enabling you to enter
an appropriate IP address.
This is a numerical field in the following format:
nnn.nnn.nnn.nnn
Enter the address and press
ENTER.
Does not display for DHCP
Displays this prompt so that you can enter the subnet mask
number.
This field is also numerical in the same format as the IP
address.
Enter the subnet mask number and press
ENTER.
Unit[n] SN1234 10 cm3
Communications
Requesting Address
[ENTER} to continue
Unit[n] SN1234 10 cm3
Communications
Assigned Address:
(assigned address)
Unit[n] SN1234 10 cm3
Communications
Requesting Address
[ENTER} to continue
Unit[n] SN1234 10 cm3
Communications
Requesting Address
[ESC} to cancel.
Unit[n] SN1234 10 cm3
Communications
IP Address:
(user-entered)
Unit[n] SN1234 10 cm3
Communications
Subnet Mask:
(user-entered)