Using the PRO1 updater 347
PRO1 Live Audio System
Operator Manual
10 Click Quit and reboot to exit the
updater and automatically reboot
the PRO1. (You can exit the
updater later by clicking Quit
later.)
The GUI will display the screen
shown right.
Do not switch off the power
until the console has fully
rebooted.
11 When the PRO1 has fully rebooted, power cycle the system (including all I/O
boxes) to restart using the new software. Do this by powering the system down
and then powering it up again (see “Powering the PRO1 system” on page 30).
To Next Page
Loading...