346 Appendix E: Updating The PRO1 Host Software
PRO1 Live Audio System
Operator Manual
6 Click Update Now. A warning window will open (see below).
7 Click Upgrade now. A window will open asking if you would like to back up your
shows.
8 Click No Thank You to start the upgrade. (If, at this point, you want to back up
your shows and preferences, click Yes Please.) The device blocks will change
colour according to their update status (see “Device blocks” on page 343). The
green bar at the bottom will show the progress of the current action. A typical
screen display during the update procedure is shown in Figure 29 “A typical
updater display” on page 342.
During the upgrade, leave all of the system devices switched on.
9 When the upgrade procedure has
finished, you will see the
“Upgrade complete” message
(shown right).
Do not switch off the power until the console has fully rebooted.
To Next Page
Loading...
Need help?
General