Miele PG8582 CD - Cancelling Programmes with Fault Codes

Problem solving guide
129
Cancel with fault code
If a programme is cancelled and a fault code appears, e.g. Fault XXX (where XXX
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
 Switch the machine off using the  button.
 Wait approximately 10 seconds before switching the machine on again with the 
button.
 Acknowledge the fault code by entering your PIN code.
 Start the previously selected programme again.
If the same message appears again:
 Make a note of the fault message.
 Switch the machine off using the  button.
 Contact Miele Service.
Please also read the notes regarding the following fault codes.
Problem Cause and remedy
Fault 403-405 A programme has been cancelled because water intake by
the machine was insufficient or severely restricted.
 Open the stopcocks fully.
 Follow the additional information given in the Check
water inlet message.
Fault 406-408 A programme was cancelled because the water inlet
volume is insufficient.
 Check whether the stopcocks are fully opened.
 Refer to the information regarding minimum flow
pressure in "Plumbing" and "Technical data".
 Check the filter in the water inlet.
 Contact Miele Service for advice.
Fault 412-414 A programme was cancelled because the water inlet
volume is too high.
 Refer to the information regarding recommended
maximum flow pressure and maximum permissible static
water pressure in "Plumbing" and "Technical data".
 Contact Miele Service for advice.
Fault432 The door was opened using the emergency release.
 See "Opening the door using the emergency release".
Fault 433 Protruding wash load items or other objects, e.g. towels,
are preventing the door from being closed properly by the
Comfort lock.
 Remove all objects and sort the wash load so that it
does not obstruct the door.
 Close the door.