Adding and dispensing chemical agents
58
Chemical disinfectant
Heat-sensitive items, e.g. theatre shoes can be disinfected using a
chemical disinfecting agent.
The disinfecting agent must be suitable for machine use and must be
low-foaming.
Disinfecting parameters are based on claims made by the disinfecting
agent manufacturer. Please observe, in particular, their instructions
on handling, conditions of use and effectiveness.
Chemo-thermal procedures are not suitable for the
reprocessing of medical products.
These must be reprocessed in a washer-disinfector which has a
special programme set up by Miele Service and which is equipped
with an additional internal dispensing system.
Replenishing
chemical
disinfectant
Open the drawer in the side unit.
Remove the chemical agent container (green marking) and place it
on the open cabinet door or on a surface which is robust and easy
to clean.
Unscrew and remove the siphon. Place the siphon on the open
cabinet door.
Replace the empty container with a full one.
Push the siphon into the opening of the container and screw it back
on tightly. Observe the colour coding.
Wipe up any spilled chemical agent thoroughly.
Place the container back in the drawer in the side cabinet.
Close the drawer. Ensure that the dispensing tubes and cables are
not kinked or trapped.
The dispensing system must then be vented (see "Settings /DOS
venting").
To Next Page
Loading...
