Miele PG8582 CD - Water Inlet and Drainage Troubleshooting

Problem solving guide
140
Problem Cause and remedy
Excessive spray pressure
fluctuation
A programme was interrupted because of severe
fluctuations in the wash pressure.
Possible causes of fluctuations in the wash pressure
include:
-Defective water connections,
-Open adapters,
-Foam build-up.
 Identify and resolve the cause of this.
 Reprocess the load again.
Water inlet and drainage
Problem Cause and remedy
Check water inlet One or more stopcocks are closed.
 Open the stopcocks.
There was insufficient water in the machine.
 Clean the water intake filters.
 Open the stopcocks fully.
The supply pressure at the water connection is too low.
 Refer to the specifications for supply pressure in the
"Technical data".
 Contact a suitably qualified installer.