Adding and dispensing chemical agents
61
Close the drawer. Ensure that the dispensing tubes and cables are
not kinked or trapped.
The dispensing system must then be vented (see "Settings /DOS
venting").
Checking
consumption
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in good time to avoid the
dispensing system being sucked completely dry.
Refill indicator
When the fill level is low in the DOS 1 supply container for liquid
cleaning agent you are reminded to replenish it.
Confirm the message shown with OK and
replenish the liquid cleaning agent as described.
If the liquid cleaning agent has run out, the machine will be locked
for further use.
It will be ready for use again when the supply container has been
replaced.
Dispensing liquid
cleaning agent
The dispensing concentration is set by Miele Service.