Miele PG8582 CD - Specific Fault Code Resolution

Problem solving guide
133
Problem Cause and remedy
Fault 550 The waterproof system has been activated. One of the
water intake hoses might have a leak.
 Close the stopcocks.
 Contact the Miele Service Department.
Fault555 Too much water has accumulated in the steam condenser.
 Restart the machine. Excess water is pumped out
automatically.
Fault559 There is a problem with the process documentation
interface. The machine has detected a module for an
Ethernet interface, but only a serial interface (RS232) is
activated in the controls.
Deactivate the RS232 interface:
 Open the menu for configuring the interface Further
settings/Interface and then select Ethernet.
 Wait approx. 90seconds. The Ethernet module XKM
3000 L Med needs this time for initialisation. It may be
necessary to reconfigure the interface.
Or
 Replace the Ethernet module XKM 3000 L Med with a
XKM RS232 10 Med module to set up a serial interface.
Fault578 The peak-load cut-out has lasted longer than 3hours.
 Have your electrical system and your energy
management system tested by a suitably qualified
person.
Process-related faults and messages
Problem Cause and remedy
Change coarse filter The maximum permissible operating hours for the coarse
filter have been reached.
 Replace the coarse filter with a new one.
 Reset the operating hours counter for the coarse filter.
Change HEPA filter The maximum permissible operating hours for the HEPA
filter have been reached.
 Replace the HEPA filter with a new one.
 Reset the operating hours counter for the HEPA filter.
Drying during programme
deactivated
Drying cannot be selected at the start of a programme
because drying is not available for the selected programme.
 Start the programme without drying.
or
 Have the drying parameters for this programme adjusted
by Miele Service.