Miele PG8582 CD - Page 132

Problem solving guide
132
Problem Cause and remedy
Fault526 The supply pressure has dropped below the minimum
value.
- The water pressure is too low due to a heavy build-up of
foam. Spilled rinsing agent may not have been cleaned up
after being added.
 Follow the instructions regarding foam build-up in
"Chemical processes and technology".
 Start the Rinsing programme in order to clean the wash
cabinet.
- The carriers were loaded incorrectly or overloaded.
 Use only mobile units, baskets, modules and inserts
suitable for the particular application.
 Arrange hollow or deep-sided wash load items so that
water runs off them freely.
- The water lines are clogged or leaking.
 Check and clean the filters in the wash cabinet and spray
arms.
 Check the injector bars for possible leaks, e.g.:
– Are all caps and end caps in place?
– Are all connections fitted with nozzles, irrigation sleeves, hose
adapters or other washing attachments?
– Are installed silicone hoses undamaged?
 Check the washer's water connectors in the back panel
of the wash cabinet to ensure that they are attached
tightly, and remove any blockages.
- The amount of water may be insufficient for the
application.
 Increase the amount of water (see "Programme
settings"). If necessary, consult Miele Service.
Fault542 A programme was cancelled because the water in the wash
cabinet is only being pumped away slowly or not at all.
- The drain hose is blocked.
 Remove any kinks or large loops in the drain hose.
- The filters in the wash cabinet are blocked.
 Danger of injury from glass shards, needles, etc.
retained in the filters.
 Clean the filters in the wash cabinet.
- The drain pump or the non-return valve is blocked.
 Clean the access to the drain pump and the non-return
valve.
- The drainage system cannot take in enough water
because it is blocked.
 Contact a suitably qualified installer.