Plumbing
153
– The inlet hose is approx. 1.7m long terminating in a ¾" female
thread. On no account may the inlet filter be removed.
– Install the filter (supplied in accessory pack) between the stopcock
valve and the inlet hose. The filter for AD water is made of
chromium-nickel steel and can be recognised by its dull surface.
IMPORTANT
UK, Australia and New Zealand
For the UK, Australia and New Zealand a non-return check valve is
required between the tap and filter.
Do NOT shorten or otherwise damage the inlet hoses (see
diagram).
See installation diagram supplied.
To Next Page
Loading...
