Miller Multimatic 220 - TIG Postflow Control Adjustment

OM-281426 Page 44
F
Complete Parts List is available at www.MillerWelds.com
6-20. TIG Postflow Control (Menu 12 Of 12)
 A complete Parts List is available at www.MillerWelds.com
OM-281426 Page 33
3-19. TIG Postflow Control (Menu 12 Of 12)
Ref. 281252A
1
2
3
4
1 Wire/Rod/Tungsten Minus (-) Button
2 Auto-Set Button
3 Material Thickness Plus (+) Button
4 Right Encoder
Follow instructions in Section 6-8 to enter
the setup menu.
To adjust TIG postflow, turn right encoder.
Postflow can be adjusted from Auto-25
seconds.
To exit menu, simultaneously press and re-
lease the Wire/Rod/Tungsten Minus (-) but-
ton and Material Thickness Plus (+) button,
or turn unit off and on.