Millipore Synergy

To Next Page

To Previous Page

INTRODUCTION

Feedwater Tubing .......................................................................................................... 9

4-3 CONNECTION OF THE POWER CORD − TURNING ON THE SYSTEM POWER ........................... 10

Start-up Displays.......................................................................................................... 10

4-4 INSTALLATION OF THE SYNERGYPAK ............................................................................ 11

Installation .................................................................................................................. 11

4-5 INSTALLATION OF THE TYGON TUBING......................................................................... 13

4-6 PURGING AIR FROM THE SYSTEM ................................................................................ 14

4-7 HYDRATING THE SYSTEM.......................................................................................... 14

4-8 INSTALLATION AND RINSING OF THE FINAL FILTER ............................................................15

4-9 HOW TO CALIBRATE THE FLOWRATE FROM THE SYNERGY (F02) .......................................... 16

4-10 HOW TO SHOW RESISTIVITY OR CONDUCTIVITY UNITS (C01)............................................ 18

With Temperature Compensated or non Temperature Compensated values............................ 18

4-11 HOW TO SET THE RESISTIVITY SETPOINT (C02)...............................................................20

HAPTER 5 USING THE SYNERGY....................................... 22

5-1 UNDERSTANDING THE DISPLAY................................................................................... 22

5-2 HOW TO GET WATER FROM THE SYNERGY................................................................... 22

Using the Dispensing Button........................................................................................... 22

How to Dispense an Exact Amount of Product Water (F01) ................................................. 23

5-3 OPERATING MODES ............................................................................................... 25

Standby ..................................................................................................................... 25

Pre Operate................................................................................................................ 25

Dispensing.................................................................................................................. 26

Auto-Dispensing ..........................................................................................................26

5-4 HOW TO VIEW THE PRODUCT RESISTIVITY AND TEMPERATURE IN PRE OPERATE MODE ................. 27

5-5 HOW TO RECIRCULATE WATER MANUALLY BEFORE DISPENSING............................................ 27

5-6 HOW TO UNDERSTAND SYNERGY MESSAGES................................................................ 28

Pack Alarm................................................................................................................. 28

UV Lamp Alarm ........................................................................................................... 28

CHAPTER 6 MAINTENANCE .............................................. 29

6-1 MAINTENANCE SCHEDULE .......................................................................................29

Millipore Synergy - Page 6