Chapter 5 Dealing with Problems
119
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
9
Close the front cover.
10
Set the exposure time, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display.
• Cleaning is performed automatically once print nozzle washing has ended.
• If print defects (e.g., nozzle clogging, deflection) remain unresolved even after washing
the nozzles several times, contact your local dealer or our service office.
The heater temperature does not rise to the specified value.
This may indicate a problem with the setting.
Points to check Corrective action
Is the 100V/200V selector switch set correctly? Set the selector switch according to the power
supply voltage.
Is the heater temperature set? Set the heater temperature.
"Setting the Heater Temperature"(P. 57)
"Setup Menu"(P. 72)
The ink has leaked.
• If an ink leak occurs, turn off the main power immediately and unplug the power cable. Contact
your local dealer or our service office.
5
To Next Page
Loading...
