MIMAKI jV100-160 - Event Email Function Settings

Chapter 3 Settings
83
6
Select [600cc cartridge] > [Case Weight], then press the [ENTER] key.
7
Select the required ink slot, then press the [ENTER] key.
• The selected slot is highlighted.
8
Enter the measured weight of the 600 ml ink cartridge case, then press the [ENTER] key.
• Check the following when “ERROR614 Preservation Failure” appears:
(1) Check to confirm that the 600ml ink cartridge was fully inserted.
(2) Check to confirm the ink IC chip was installed correctly.
Correcting the Ink Cartridge Case Weight
When the remaining ink level in the 600 ml ink cartridge reaches a preset level, [Ink Level Low], [Ink Near
End], [Ink Level End], or [Ink End] appears on the display. The weight may differ from the actual weight, so
the weight of the 600 ml ink cartridge should be corrected.
• If non-actual weights are registered repeatedly, the ink IC chip can no longer be used.
• Continuous printing is not possible when the warning is displayed.
• Replace with a new ink pack when “Replace Inkpack” is displayed.
1
A warning appears on the display.
2
Remove the 600 ml ink cartridge case in the indicated ink slot, and measure the weight.
• Weight with the ink pack inserted.
3
Insert the 600 ml ink cartridge in the ink supply unit.
• The cartridge weight screen appears.
4
Enter the measured weight of the 600 ml ink cartridge, then press the [ENTER] key.
• The remaining ink amount of the ink pack is calculated and saved in the ink IC chip.
• The weight of the 600ml ink cartridge can be registered as follows:
(1) On the LOCAL mode screen, select [MENU] > [Machine Setup], then press the [ENTER] key.
• The Machine Setup menu is displayed.
(2) Select [600cc cartridge] > [Cartridge Weight], then press the [ENTER] key.
(3) Select the required ink slot, then press the [ENTER] key.
• The selected slot is highlighted.
(4) Enter the measured weight of the 600 ml ink cartridge, then press the [ENTER] key.
• Check the following when “ERROR614 Preservation Failure” appears:
(1) Check to confirm that the 600ml ink cartridge was fully inserted.
(2) Check to confirm the ink IC chip was installed correctly.
Event Email Function Settings
An email can be sent to a specified email address when an event (e.g., print start, print end, and abort)
occurs.
3