Chapter 1 Before Using This Product
21
Rear and Right Side View
No. Name Outline
1 Clamp lever (rear) Linked to the clamp lever at the front.
2 Media sensor Detects whether media is present. "Media sensor"(P. 24)
3 Blowing fan Blows air to dry ink after printing.
4 Preheater Preheats the media before printing to suppress rapid temperature change.
Adjust the temperature setting to suit the type of media used. "Setting
the Heater Temperature"(P. 57)
5 Feeding unit Holds the roll media before printing. Compatible with 2-inch and 3-inch
paper rolls
6 AC inlet The inlet at the front (INLET2) is for the heater and the inlet at the rear
(INLET1) is for the machine. Used to connect the power cable (provided).
"Connecting the Power Cable"(P. 30)
7 Main power supply
switch
The power supplies at the front and rear are for the heater and the machine
respectively. To prevent print defects attributable to the print head (e.g.,
nozzle clogging, deflection), do not turn off the main power supply.
"Turning On the Power"(P. 30) "Turning Off the Power"(P. 31)
8 LAN port Used when using the network function. "Using a LAN Cable"(P. 32)
9 USB port Connects to PC via a USB interface cable. "Using a USB Cable"(P. 32)
10 Maintenance liquid
cartridge
Used to automatically feed maintenance liquid to the cap, to drip liquid on to
the wiper to prevent ink solidification, and to prevent ink solidifying inside the
ink discharge channel during maintenance.
1
To Next Page
Loading...
