Chapter 3 Settings
82
Item
Setting
*1
Details
Pass Word - Sets the password used for authentication (not to exceed 15
alphanumeric characters or symbols).
• This can be set when [Authentication] is not set to “OFF”.
POP3
Address
- Sets the POP server.
• This can be set when [Authentication] is set to “POP before
SMTP”.
APOP - Enables or disables APOP.
• This can be set when [Authentication] is set to “POP before
SMTP”.
Transmit Test - Sends a test email. "Transmit Test"(P. 84)
Auto Remote ON/OFF Sets whether to automatically switch to REMOTE mode and start
printing if data is received locally.
Feeding Before Cut ON/OFF Sets whether to feed media before cutting the media.
Reset - Initializes the details set.
*1. The default settings are shown underlined.
Registering and Correcting a 600 ml Ink Cartridge
l
Required Items
Name Outline
600 ml ink cartridge
case
The 600 ml ink pack and the ink IC chip provided with the ink pack are placed in
the 600 ml ink cartridge case.
600 ml ink pack
Ink IC chip
Scale The weight of the 600 ml ink cartridge is registered to calculate the amount of
remaining ink. Use a scale capable of weighing in 1 g increments.
Replacing with a New Ink Cartridge
Register the case weight.
1
Attach a new ink IC chip to the 600 ml ink cartridge case.
2
Weigh the 600 ml ink cartridge case.
• Do not install the ink pack at the stage.
3
Place the ink pack in the 600 ml ink cartridge case.
• "Replacing Ink"(P. 39)
4
Insert the 600 ml ink cartridge in the ink supply unit.
5
On the LOCAL mode screen, select [MENU] > [Machine Setup], then press the [ENTER] key.
• The Machine Setup menu is displayed.
To Next Page
Loading...
