Chapter 2 Printing
65
2.9 Printing RIP Data
Check beforehand
• Was the print head adjusted? "Adjusting Print Head Height"(P. 49)
• Is media loaded? "Loading the Media"(P. 51)
• For roll media, is the rear roll media free of sagging?
• When using the take-up unit, was the media mounted on the core of the take-up unit? "Loading the
Roll Media"(P. 51)
• Condensation may form on the print head nozzle surface depending on the ambient
temperature and humidity. The formation of condensation may cause printing defects (e.g.,
nozzle clogging or deflection). Perform head cleaning if any printing defects (e.g., nozzle
clogging or deflection) occur during printing. Set the platen heater to a temperature not
exceeding 35 °C, and ensure that the ambient temperature is within the permissible operating
temperature range (20 °C to 30 °C).
"Head Cleaning"(P. 60)
"Installation Precautions"(P. 14)
Preparing RIP Data
The explanation here applies to MIMAKI RIP software (RasterLink).
• Prepare suitable image data for printing.
1
Launch RasterLink.
• Click the icon on the PC desktop.
2
Select the image data to print.
(1) Select [File] > [Open].
(2) Select the desired image data, then click [Open].
• If multiple printers are registered, select JV100-160 in “Printer name”.
2
To Next Page
Loading...
