MIMAKI jV100-160 - Media Sensor; Take-Up Unit; Power Supply Switch

Chapter 1 Before Using This Product
24
Color Status Outline
Red Illuminated One of the following errors has occurred: Printing is not possible.
• INK END
• The ink IC chip is not inserted.
• Other ink errors
Flashing Printing is not possible.
• Ink expired (2 months passed)
Media sensor
The media sensor detects the presence/absence of media.
Media sensor
• The sensor must be covered by the media to detect the media width.
Take-up unit
Use the switch on the take-up unit to change the media take-up direction.
Direction selector switch
ON/OFF button
Name Outline
Direction selector
switch
Up To take up media with printed surface on the inside
Down To take up media with printed surface on the outside
ON/OFF button Press the button to start/stop the take-up unit. The setting can be altered so that the
take-up unit operates only while the button is depressed. "Machine setup
menu"(P. 79)
Power supply switch
This product has the following power supply switches.