MIMAKI jV100-160 - Error Messages

Chapter 5 Dealing with Problems
123
Message Cause Corrective action
3. Remove the lid on the ink cartridge and fold
the ink pack. "Replacing Ink"(P. 39)
INK LVL LOW (2nd time) • The ink remaining in the
600 ml cartridge is below
60 ml.
1. Remove the ink cartridge, and measure the
weight. "Correcting the Ink Cartridge
Case Weight"(P. 83)
2. Enter the measured weight into the
machine. "Correcting the Ink Cartridge
Case Weight"(P. 83)
– “Ink near end” is displayed when the
remaining ink has dropped to less than
60 ml.
Ink level end • The ink remaining in the
600 ml cartridge is below
30 ml.
1. Remove the ink cartridge, and measure the
weight. "Correcting the Ink Cartridge
Case Weight"(P. 83)
2. Enter the measured weight into the
machine. "Correcting the Ink Cartridge
Case Weight"(P. 83)
– “Ink end” is displayed when the
remaining ink has dropped to less than
30 ml.
– “Ink near end” is displayed when there
is at least 30 ml of remaining ink.
Remove the lid on the ink cartridge
and fold the ink pack. "Replacing
Ink"(P. 39)
Cartridge abnormality • The ink usage amount
exceeded the preset
value.
• Replace with new ink. "Replacing
Ink"(P. 39)
• Check to confirm the nozzle is not
clogged.
Error messages
Error
number
Message Cause Corrective action
04 PARAM ROM • A problem was detected
with the main PCB.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
5