Chapter 3 Settings
79
3.3 Machine setup menu
This is used to set various operations to ensure optimal machine performance.
l
Menu List
Item
Setting
*1
Details
Auto Power-off None/5 min to
15 min to 600
min
Sets the time until the power is automatically turned off.
Auto Power-on - Sets the time to automatically turn on the power.
SETUP ON/OFF Sets whether to turn on or off the power.
Time 0:00 to 23:59 Sets the time to turn on the power.
Day of week - Sets whether to turn on or off the power on each day of the week.
Nozzle check ON/OFF Automatically executes the nozzle check function when the machine
is started with auto power-on. Performs nozzle recovery (cleaning
followed by nozzle checking) if “nozzle clogging” is detected.
Cleaning Soft/Normal/
Hard
Sets the cleaning type.
Retry Count 0 to 3 times Performs nozzle recovery (cleaning followed by nozzle checking) for
the specified number of times.
Take-up Unit - Sets the take-up unit operation.
Take-up Unit ON/OFF Set to “OFF” if the take-up unit is not used.
Take-up SW Continuous/
Temporary
Sets the function performed by the ON/OFF button on the take-up
unit in LOCAL mode.
• Continuous: Press the button to start/stop the take-up unit.
• Temporary: The take-up unit operates only while the button is
pressed. The unit stops when the button is released.
Drying/Exhaust FAN - Set when the optional drying/exhaust fan is used. For more
information, refer to the operation manual for the drying fan unit.
STOP TIME OFF/10 min to
120 min
Sets the time during which the drying/exhaust fan operates after
printing. After the set time passes, the fan stops.
ON/OFF ON/OFF Set to “ON” to operate the drying/exhaust fan when printing is not
performed.
Top blower ON/OFF Sets the blowing fan operation during printing.
STRENGTH AUTO/Weak/
Standard
Sets the blowing fan wind strength.
Media Remain ON/OFF The remaining roll media amount can be displayed and printed out in
REMOTE mode.
• ON: An input screen appears once the media width is detected.
Press to set the media length.
Press the [FUNC3] key on the “Origin Setup” screen to print the
date and remaining media amount.
• OFF: The remaining media amount is not displayed.
Media Detect - Sets the media width detection method.
DETECTION
TYPE
AUTO/
MANUAL
• AUTO: The media width is automatically detected with the
sensor.
• MANUAL: Press to set the media width manually.
3
To Next Page
Loading...
