Chapter 2 Printing
67
– Scan (lateral, Y’) direction: 15 mm from right edge of media
Cutting
slot
Approx. 75 mm (X')
15 mm (Y')
1
On the LOCAL mode screen, press .
• The Origin Setup screen appears.
2
Press to move the origin to the desired position.
• The carriage moves left and right and feeds the medium.
3
Press the [ENTER] key.
• The origin is updated.
Starting Printing
1
Send the RIP data from the PC.
• "Preparing RIP Data"(P. 65)
• When the message “Attention20A Driver version” appears, install the latest Mimaki driver
available from:
https://mimaki.com/download/inkjet.html
2
Start printing.
• Printing starts once RIP data is received.
0.0m
600x600 16p / Bi / Hi / Vd
PRINT
REMORT
Resolution
Number of passes
Scan direction (Uni: unidirectional, Bi: bidirectional)
Scan speed (Std: standard, Hi: high speed)
Dot type
VD: Variable dot
ND: Normal dot
Length of medium printed
• Print speeds may differ for the same image data, depending on the width of the medium
loaded, print origin position, and resolution.
• If an error occurs, the machine switches to LOCAL mode once printing is completed.
Further printing is not possible.
Pausing Printing
1
Press [LOCAL] while printing is in progress.
• Printing is paused.
• If data is being sent from a PC, data transmission is paused at the PC.
2
To Next Page
Loading...
