Chapter 3 Settings
74
Item Setting Details
*1 *2
SETUP File/Length/
Time/OFF
- Sets the conditions to perform auto head cleaning.
Interval - - Sets auto head cleaning intervals.
(File) 1 to 1,000 - Sets the interval at which the number of files is selected.
(Length) 0.1 m to 100.0
m
- Sets the interval at which the print length is selected.
(Time) 10 to 60 to
240 min
- Sets the interval at which the print time is selected.
Type Normal/Soft/
Hard
- Sets the head cleaning type.
Cleaning Check ON/OFF - Sets whether nozzle checking is performed after auto head
cleaning is completed.
External heater ON/OFF - Set when the external heater is used. For more information,
refer to the operation manual for the small relay box.
MAPS4 - - MAPS: Mimaki Advanced Pass System
• This function disperses the boundaries between passes to
make feed streaks between passes less visible.
• Altering MAPS may alter the color. This function may be
less effective with certain types of images.
MAPS4 AUTO/
MANUAL
- This should normally be set to “AUTO”. When set to
“MANUAL”, the following items are displayed:
Smoothing
Level
0 to 100 % - Increasing smoothing makes streaks less visible.
Speed 50 to 100 % - Reducing speed will make streaks less visible. However,
printing will be slower.
Expansion ON/OFF - Selecting “ON” will make streaks less visible. However, it may
increase visible grain.
Setup Reset - - Initializes the details set.
*1. The default settings are shown underlined.
*2. Settings applied if no settings can be made in the RIP software (host) or if this machine is prioritized.
Changing the name of a setting type
You can change the name of a setting type. The name can include alphanumeric characters or symbols.
1
On the LOCAL mode screen, select [MENU] > [Setup], then press the [ENTER] key.
• The setting types are displayed.
2
Select Settings 1 to 4 and press the [FUNC2] key.
• The rename screen appears.
3
Enter the desired name, then press the [ENTER] key.
• The setting type is renamed.
To Next Page
Loading...
