MIMAKI jV100-160 - Installing RIP Software; Obtaining Color Profiles

Chapter 1 Before Using This Product
35
Installing RIP Software
The explanation here applies to MIMAKI RIP software (RasterLink).
1
Install RasterLink.
• The following icon appears on the PC desktop once the software has been installed.
• For more information, refer to the RasterLink installation guide.
https://mimaki.com/download/software.html
• Once installed, activate the license for Rasterlink. Otherwise, “Profile Update” will not start.
Obtaining Color Profiles
Print quality (e.g., tone, bleeding) will vary depending on the media and ink set. To maintain consistent print
quality, select a color profile that suits the media and ink set.
The explanation here applies to MIMAKI RIP software (RasterLink).
1
Launch “Profile Update”.
(1) From the Start menu, select [Mimaki RasterLink7] > [Profile Update].
(2) Click [Next].
2
Select the JV100-160 being used.
• Select the check box for the ink set and ink type being used, then click [Next].
• Expanding the [+] button allows selection of the ink type.
1