Chapter 3 Settings
80
Item
Setting
*1
Details
– When using media that cannot be detected using AUTO, set to
"MANUAL".
At Startup ON/OFF The medium is detected automatically when the clamp lever is
lowered after the machine starts up. Set to “OFF” if auto detection is
not required.
Detect Speed Fast/Standard • Fast: Clear or reflective media may not be detected. If detection
is unsuccessful, select “Standard”.
• Standard: Select “Standard” if the medium is not detected
successfully.
LANGUAGE English/
Japanese/
Chinese
Sets the display language.
Time Set -20 h to 0 to
+4 h
Sets the current time and date. (With respect to JST)
• This can be set within the range of -20 to +4 hours.
UNIT / TEMP °C/°F Sets the display unit for temperature (Celsius/Fahrenheit).
UNIT / LENGTH mm/inch Sets the display units for length and area.
• Some items are displayed in “mm” even if “inches” is selected.
600cc cartridge - Displayed when the 600ml ink cartridge is used in the ink supply unit.
Case weight - Registers the ink IC chip and the weight of the attached 600ml ink
cartridge case. "Replacing with a New Ink Cartridge"(P. 82)
Cartridge weight - Registers the weight of the 600ml ink cartridge with the ink pack
being set. "Correcting the Ink Cartridge Case Weight"(P. 83)
Key Buzzer ON/OFF Sets an audible tone when keys are pressed.
• Audible signals indicating errors, warnings, and operation end
cannot be muted, even if “OFF” is selected for this setting.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Space Btwn PP. None/10 to
500 mm
Setting the distance of the reverse feed (spaces between prints)
during continuous printing can eliminate spaces between prints.
• The reverse feed may cause sagging media, resulting in
discrepancies in the distance the media is fed. If this occurs,
rewind the media by hand to eliminate sagging before printing.
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image data.
• Intermittent: Uses intermittent feeding based on the timing of a
fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
Network - Sets the network address. The machine must be restarted to enable
this setting.
Check IP
Address
- Displays the machine’s current IP address.
• It may take some time to determine the IP address. If the IP
address cannot be determined, the display will indicate “0.0.0.0”.
Check MAC
Address
- Displays the machine’s current MAC address.
DHCP ON/OFF Select “ON” to use the IP address assigned by the DHCP server.
AutoIP ON/OFF Select “ON” to use the IP address set by the AutoIP protocol. Note
that DHCP takes priority if DHCP is set to “ON”.
IP Address - Sets the machine’s IP address.
To Next Page
Loading...
