MIMAKI jV100-160 - Page 81

Chapter 3 Settings
81
Item
Setting
*1
Details
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Default Gateway - Sets the machine’s default gateway.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
DNS Address - Sets the machine’s DNS server address.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Sub Net Mask - Sets the number of subnet mask digits used by this machine.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Event Mail - An email can be sent to a specified email address when an event
(e.g., print start, print end, and abort) occurs. The machine must be
restarted to enable this setting. "Event Email Function
Settings"(P. 83)
Mail Delivery ON/OFF Sets whether event emails are sent.
Select Event -
Print Start
Event
ON/OFF Sets whether an email is sent when printing starts.
Print End
Event
ON/OFF Sets whether an email is sent when printing ends.
Plot Start
Event
ON/OFF Sets whether an email is sent when cutting starts.
Plot End
Event
ON/OFF Sets whether an email is sent when cutting ends.
Error ON/OFF Sets whether an email is sent when an error occurs.
Warning ON/OFF Sets whether an email is sent when a warning occurs.
Other Event ON/OFF Set to send or not send an email when an event other than those
listed above occurs.
Mail Address - Sets the email address to which emails will be sent (not to exceed 96
alphanumeric characters or symbols).
Message Subject - Sets the characters contained in a message subject (not to exceed 8
alphanumeric characters or symbols).
Server Setup -
SMTP
Address
- Sets the SMTP server.
SMTP Port
No.
- Sets the SMTP port number.
Sender
Address
- Sets the sender address (not to exceed 64 alphanumeric characters
or symbols).
• Setting an email address corresponding to the server account
allows emails to be sent.
Authentication OFF/POP
before SMTP/
SMTP
authentication
Sets the SMTP server authentication method.
User Name - Sets the user name used for authentication (not to exceed 30
alphanumeric characters or symbols).
• This can be set when [Authentication] is not set to “OFF”.
3