MIMAKI jV100-160 - Page 124

Chapter 5 Dealing with Problems
124
Error
number
Message Cause Corrective action
108 HD THERMIS [1234] • A problem was detected
with print head
temperature control.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
108 HD CONNECT [1234] • A problem was detected
with the print head
connection.
122 CHECK:SDRAM • A problem was detected
with the SDRAM.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
128 HDC FIFO OVER • A problem was detected
with the print head control
PCB.
128 HDC FIFO UNDER
129 Battery Exchange • The internal clock battery
is spent and must be
replaced.
• Contact your local distributor, our
sales office, or service center.
12a HDC SPEED • A problem was detected
with the print head control.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
130 HD DATA SEQ
148 E-LOG SEQ • A log control abnormality
was detected.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
151 Main PCB V1R2 • A problem was detected
with the main PCB power
supply circuit.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
152 Main PCB V2R5
153 Main PCB V3R3
154 Main PCB V05
157 Main PCB VTT
158 Main PCB V36-2
15f HEAD DRIVE HOT • The COM drive has
overheated.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
16e Main PCB V3R3B • A problem was detected
with the main PCB power
supply circuit.
171 NEW HEAD CONNECT • A new print head
connection was detected.
18a Main PCB V_CORE • A problem was detected
with the main PCB power
supply.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
18b Main PCB V1R5B
18c Main PCB V12
18e FLS NOT COMP • A problem was detected
with the print head control.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
18f OFSET START
18f OFSET END
1e6 PRAM Size Shortage • Insufficient memory • Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)