MIMAKI jV100-160 - Page 125

Chapter 5 Dealing with Problems
125
Error
number
Message Cause Corrective action
201 Command Error • Data other than print (RIP)
data was received, or a
problem was detected
with the print (RIP) data
received.
1. Clear the data and resend.
2. Check the USB cable connection.
"Using a USB Cable"(P. 32)
3. Use a compliant USB cable. "USB
Connection Precautions"(P. 32)
4. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
202 Parameter Error • A problem was detected
with the print (RIP) data
received.
206 Printing Mode • Print (RIP) data was
received with print
parameters that do not
allow printing.
• Change the output parameters and
profile using RIP software.
20A Driver version • Printing is not possible
because the Mimaki driver
version is old.
• Install the latest Mimaki driver
available from:
https://mimaki.com/download/
inkjet.html
304 USB INIT ERR • A problem was detected
with the USB cable
connection.
1. Check the USB cable connection.
"Using a USB Cable"(P. 32)
2. Use a compliant USB cable. "USB
Connection Precautions"(P. 32)
3. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
305 USB TIME OUT
307 MCFD File IF Error • A problem was detected
while accessing print
parameter data.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
401 Motor X • The X motor was
overloaded.
1. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 51)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
3. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
402 Motor Y • The Y motor was
overloaded.
403 X Current • An overcurrent was
detected in the X motor.
404 Y Current • An overcurrent was
detected in the Y motor.
406 Wiper Move Failure • Unable to detect the wiper
origin.
1. Clean the wiper and around the wiper.
"Wiper Cleaning"(P. 92)
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
44f Take-up Roll Sns Err • A problem was detected
with the take-up unit
sensor spindle.
1. Check to confirm the [Machine Setup] >
[ Feeding/Take-up] > [Take-up Unit]
setting is “ON”.
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 51)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 24)
48a Detect winding failure • The take-up unit is unable
to take up media.
• Check to confirm the media is
loaded correctly. "Loading the
Roll Media"(P. 51)
5