MIMAKI jV100-160 - Page 52

Chapter 2 Printing
52
2
Move the rear left roll holder to the roll setting position.
• Unscrew the roll holder retaining screw before moving.
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
R ol l Ho l d er
S et P os i t io n
3 I n c h R o ll M ed i a
2 I n c h R o ll M ed i a
Position the roll holder so that the reference position is
within the following range:
There are two types of inner diameter of the roll media paper
core: 2 inches and 3 inches.
Setting position for 3-inch roll
Setting position for 2-inch roll
Reference
3
Tighten the retaining screw on the rear left roll holder.
4
Place roll media on the roll media hanger.
5
Insert the core of the roll media on to the rear left roll holder.
• Push in until the core moves no farther.
6
Insert the rear right roll holder into the core.
• Unscrew the roll holder retaining screw before moving.
7
Tighten the retaining screw on the rear right roll holder.
8
Insert the media.
• Insert into the gap between the pinch rollers and the grid rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.