5-6
Chapter 5 Troubleshooting
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message Cause Solution
ERROR 108
HD CONNECT [1234]
Abnormal connection of the print head.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears,
contact our service desk or your local
distributor to call for service.
ERROR 108
HD THERMIS [1234]
Abnormal temperature of the print head.
ERROR 122
CHECK :SDRAM
Main PCB is defective.
ERROR 128
HDC FIFO OVER
A head control error occurred.
ERROR 128
HDC FIFO UNDER
ERROR 129
BATTERY EXCHANGE
The battery life end of the main PCB is
detected.
ERROR 12a
HDC SPEED
A head control error occurred.
ERROR 130
HD DATA SEQ
ERROR 148
E-LOG SEQ
An error occurred in the control log.
ERROR 151
Main PCB V1R2
An error occurred in the power supply
system of the main PCB.
ERROR 152
Main PCB V2R5
ERROR 153
Main PCB V3R3
ERROR 154
Main PCB V05
ERROR 157
Main PCB VTT
ERROR 16e
Main PCB V3R3B
ERROR 18a
Main PCB V_CORE
ERROR 18c
Main PCB V12
ERROR 1ce
SLIDER PCB V24
An error occurred in the power supply of the
slider T PCB.
ERROR 1cf
SLIDER PCB V1R8
ERROR 1d9
Main PCB V48-1
An error occurred in the main PCB power.
ERROR 1db
Station4 PCB V48
An error occurred in the power supply of
station Ⅳ PCB.
ERROR 1dc
Station4 PCB V24
ERROR 1dd
Station4 PCB V24-A
To Next Page
Loading...
