MIMAKI UJF-3042 MkII - Setting of INK LAYERS; Setting of REFRESH LEVEL; Setting of UV MODE; Setting of WORK CHANGE

3-11
Chapter 3 Setup
3
2
2
2
Setting of INK LAYERS
Set the number of times for over painting.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press to select “INK LAYERS” ,
and press the key.
3
Press to select a set value, and
press the key.
• Set value : 1 to 9 times
4
Press the key several times to
end the setting.
Setting of REFRESH LEVEL
Set the refreshing revel for preventing the head from
clogging in a dusty environment.
The larger level number indicates more frequent
refreshing times.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press to select “REFRESH” , and
press the key.
3
Press to select a set value, and
press the key.
• Set value : HOST / Level 0 to 3
4
Press the key several times to
end the setting.
Setting of UV MODE
The mode of the LED UV may be set in 3 stages.
This setting is made when the media vulnerable to the
heat is used or when the test drawing is made in which
the lighting of the LED UV is not desired.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “UV MODE” , and
press the key.
4
Press to select a set value, and
press the key.
• Set value : ON/OFF/NO PRINT
5
Press the key several times to
end the setting.
Setting of WORK CHANGE
Set whether to return to LOCAL or to remain at REMOTE
to set media after on-line drawing.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “WORK
CHANGE” , and press the key.
4
Press to select a set value, and
press the key.
• Set value :ON/ OFF
5
Press the key several times to
end the setting.
ON The LED UV is lit.
OFF The LED UV is not lit.
NO
PRINT
The drawing is not performed and only the LED UV
is lit. Use when drawing is performed without the
LED UV is lit etc., and when you wish to make it
cure afterward.