For safe operation
ix
Precautions for use
• Be sure to wear goggles and gloves for
handling the antifreeze liquid.
Circulating water
• If you find any water leaks on the maintenance
parts, turn the power switch off immediately,
and remove the power plug from the power
socket.
Note on maintenance
• When cleaning the ink-station or the heads,
make sure to wear the attached goggles and
gloves.
• The gloves supplied with the machine are
disposable. When all the gloves are
expended, purchase an equivalent product on
the market.
• Keep ink away from an open flame. Also keep
the room well ventilated when you use or
handle ink.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least
15 minutes. In doing so, also wash eyes to
rinse ink away completely. Then, consult a
doctor as soon as possible.
• If anyone drinks ink by mistake, keep him or
her quiet and see a doctor immediately. Do not
allow him or her to swallow the vomit.
• Then contact the emergency number written in
SDS.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air and
then keep yourself warm and quiet. Then,
consult a doctor as soon as possible.
• Store ink cartridges in a place that is out of the
reach of children.
• If the ink adheres to your skin, use a large
amount of water and soap or special
detergent.
CAUTION
Warning labels
• Warning labels are adhered on this machine.
Be sure to fully understand the warnings given
on the labels. In the case where any of the
warning label has become so soiled that the
warning message is illegible or has come off,
purchase a new one from your local distributor
or our office.
WARNING
Ink bottles
• If the ink bottle is moved from a cold place to a
warm place, leave it in a place of use for three
hours or more and use it.
• Open the ink bottle just before installing.
Leaving it open for a long time will cause
abnormal printing.
• Be sure to store ink bottles in a cold and dark
place.
• Once the ink opened, be sure to use ink up
early. The ink passed for a long time after
opening the bottle will lower the printing
quality.
• Using other than exclusive ink will break this
machine. In this case, repairing of this
machine is your responsibility.
• Never refill the ink bottle with ink.
• Do not pound the ink bottle nor shake it
violently. If so, ink may leak out of the bottle.
Protection against dust
• It is strongly recommended to use the
machine in a room that is not dusty.
Set the Refresh level 2 or 3 when in bad
environment.
• Do not forget to close the front cover before
going home in the evening. If any media is left
on the printer, dust can put on it.
• Store media not to put dust on it. Wiping dust
off the media, dust will be put on the media
due to static electricity.
Handling of cleaning solution
• Be sure to store the cleaning solution in a cold
and dark place. Store the cleaning solution in
a place that is out of the reach of children.
Handling the antifreeze liquid
• Be sure to store the antifreeze liquid in a cold
and dark place.
• Store the antifreeze liquid in a place that is out
of the reach of children.
Hot parts
• The LED UV device and the hot water will
have a very high temperature. When carrying
out maintenance, wait until the temperature
has been sufficiently lowered after the lamp is
turned OFF.
• When it is unavoidable to touch hot parts, be
sure to wear heat-insulating gloves to protect
your hands.
Power supply
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
CAUTION
To Next Page
Loading...
