2-3
2
2
2
5
6
Chapter 2 Basic Operation
Turning the Power ON/OFF
Turning the Power ON
This machine is provided with the following two power
switches:
Main power switch :
It is located on the side of this machine.Keep this switch
ON all the time.
[END/POWER] key :
Normally, use this key to turn the power ON/OFF.
The function for preventing ink sedimentation works
even with the [END/POWER] key turned OFF when the
main power switch is turned ON.
1
Turn the main power switch ON.
• Set the main power switch located on the side of
this machine to the “I” side.
• The firmware version is displayed when the power
is turned ON, and then the machine performs its
initial operation.
2
Turn the power on, by pressing the
key.
3
Turn ON the power of the connected PC.
Turning the Power OFF
When having ended the operation of the machine, turn the
power OFF by pressing the [END/POWER] key.
Check the following items when turning the power OFF.
• If the machine is receiving data from the PC or if there
is any data that has not been output yet
• If the head has returned to the capping station
• If any error has occurred
( P.5-6 “Error messages”
)
1
Turn OFF the power of the connected PC.
2
Turn the power off, by giving the
key a long press.
• Do not turn OFF the main power switch located
on the side of the machine.
• To use this machine again, press the [END/
POWER] key.
• Turn the power ON after the front cover and
maintenance cover are closed.
• The head nozzle may result in nozzle clogging if
the main power switch is left OFF for a long time.
To Next Page
Loading...
